![]() ![]() It can be difficult to "grab" sometimes so you may need to Zoom in to make it easier and lay off the coffee before-hand :-) If the "ruler" isn't visible, you can make it visible from the "View" tab - just put a check-mark next to "Ruler". Sections, Section Breaks, Page Numbering, Columns, Headers and Footers, and Watermarks in Microsoft Word Word 2007-2021 (365) (for Word 97-2003 click here) Introduction. If your "ruler" is visible across the top and left side of the window, "grab" the the marker indicating where the applicable margin is and drag it to where you want it. You can also access "Page Setup" from the PRINT window when you're previewing your document. 3-On the "Margins" tab, manually change the (left) margins as necessary and make sure that "Apply to Whole document" is selected at the bottom. Word automatically sets a one-inch page margin around each page. 2) if new sections are added to the document, you have to manually deactivate Link to Previous in the first new section. ![]() 2-Open "Page Setup" (there should be a small arrow to access these settings to the right of the words "Page Setup"). 1) the margins of the FIRST page are 2.5 (top) and 1 (bottom) on the first page and 1 (top) and 1 (bottom) on subsequent pages. In the Indentation section, click on the down triangle under Special and select First Line. To change the size of the margin in a document you are working on, click on the Page Layout tab at the top of the ribbon (in between Design and References), then click on the Margins icon on the. To accomplish this, go to the Home or Page Layout tab 2. Set the margins in your first section so that even if mirrored, they are the same. Instead of pressing the tab key or the space bar 5 times, use a first line indent. If not, here a couple of other options (I'm working from Word 2010 but other versions should be similar):ġ-Select the "Page Layout" tab across the top of the window. Mirrored margins are a document, not a section attribute, as is different even and odd setting for headers/footers. Now here’s another way to close the header and footer: just double-click the document. Let’s insert Banded, so the design is the same as the header. I'm not exactly sure where the problem exists but Danielle's response below should work. Now the header we just added doesn’t start until the second page. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |